Telephone Numbers
AMLA MEDIQUIP 28/31Old Rajinder Nagar, New Delhi -110 060 INDIA Voice Phone : +91-11-25852291, 25853090 Fax +91-11-25860163 Cell +91-9810126883 VOIP Number (For Video Conferencing and
Telemedicine)+91-11-29603306
MODELS AVAILABLE : Basic - Now in a new plastic body with digital timers, Clinical and Hospital
INTRODUCTION
VIPEL. is a system designed after extensive research
on Elephantiasis of Indian patients. You can be rest assured that it will
go a long way in solving your patients problems.
MECHANISM OF ACTION
VIPEL is a variable Intermittent Pneumatic External
limb compression system.
This essentially consists of two parts.
(a) The pump and
(b) The encasing which has different sizes and
shapes to suit your needs.
The classical recommended treatment of lymphoedema
is elevation, massage and compression stocking. The VIPEL compression system
provides a mechanical pumping action on the lymph distended tissues of the
limb pushing the extra cellular fluid back into the vascular compartment.
This is more than a simple massage effect as explained herein.
The mono-locular chamber pushes the
fluid in all directions with only a little going upwards. The hardened dermis
and subcutaneous tissue of lymphoedematous patients absorbs the pressure
distributing it in a centrifugal direction due to an arch effect
Compressed tissue is known to increase internal
heat generation - activating the infection fighting cells - namely the macrophages
to breakdown tissue protein. Decreased tissue protein is known to help in
tissue fluid (i.e. the oedema) reabsorption.
Essentially the limb is completely enclosed
in an inflatable encasing which is then inflated by the VIPEL pump. A rhythmic
cycle of full pressure and zero pressure is then initiated to bring out the
above mentioned effect.
THE PUMP (VIPEL
PUMP) is an intermittent source of air pressure to the encasing which is
wrapped around the affected or required limb. The air pressure is varied
by the three different knobs provided on the front panel.
TIMER ON - This regulates flow to the
encasing. It can be set between 10-180 seconds. During this time (After the
initial filling period) the encasing will press the limb for the time set.
The pressure gauge needle will rise slowly to the peak pressure required
and remain their till this timer function is completed and switched to off.
TIMER OFF - This is also a variable
time setting device to regulate between 10-90 seconds for switching OFF
the air pressure supplied to the encasing. During this time the pressure
gauge needle will drop slowly to zero indicating that pressure is now equal
to atmosphere pressure and remain so till the set time is completed. The
off timer starts working as soon as the on time is completed. The TIMER
ON will again switch on once the TIMER OFF finishes its function and hence
the entire cycle is repeated automatically continuously till the machine
is switched off. An indicator lamp glows every time the Timer On is in function.
PRESSURE CONTROL KNOB - This is used
to control the pressure transmitted to the limb. When fully opened, the pressure
to the encasing will reach up to 160 mm mercury (an automatic release valve
does not allow pressure beyond this for patient's safety).